Simple Switch

How to Switch to LED Lights

By the Simple Switch Editorial Team · Updated November 16, 2026

Woman screwing a light bulb into a bedside table lamp

To switch to LED lights, choose bulbs by brightness in lumens rather than watts, pick a color temperature that suits the room, and make sure the bulb fits the fixture, any dimmer, and whether the fixture is enclosed. Start with the bulbs you use most, then replace others as they burn out. Old fluorescent bulbs need special disposal; LEDs and incandescents depend on local rules.

Lighting is one of the easiest projects in our Home Energy section, and it's usually a good early win for renters and homeowners alike.

Why switch at all

LED bulbs use less electricity than incandescent bulbs to make the same amount of light, and they generally last much longer. They also run cooler. They do cost more upfront than incandescent bulbs, so how much any household benefits depends on how many hours each light is on and your local electricity rates. That's why the bulbs you use most come first.

Brightness: think lumens, not watts

Watts measure how much power a bulb uses. Lumens measure how much light it gives off. With old incandescent bulbs, people learned to read watts as brightness, but LEDs make the same light with fewer watts, so watts no longer tell you how bright a bulb is.

Most LED packages make this easy by listing an "equivalent" wattage, such as "60-watt equivalent," alongside the lumens. To replace a bulb:

  1. Note the wattage of the old incandescent bulb (often printed on the bulb or the fixture).
  2. Look for an LED with the matching "equivalent" wattage.
  3. Compare lumens if you want it a little brighter or softer.

Many packages also show a "Lighting Facts" panel with lumens, estimated yearly energy cost, life, and color.

Color temperature: warm to cool

LED light comes in different shades of white, measured in kelvins (K). Lower numbers look warmer and more yellow; higher numbers look cooler and bluer.

LookGeneral rangeCommon uses
Warm whiteLower kelvin, often around 2700K to 3000KLiving rooms, bedrooms, dining areas
Neutral or bright whiteMid range, often around 3500K to 4100KKitchens, bathrooms, laundry rooms
DaylightHigher kelvin, often around 5000K and upGarages, workshops, task lighting

These ranges are common starting points, not rules. If you're unsure, buy one bulb, try it at night, and see if you like it before buying a full pack. Using the same color temperature throughout a room tends to look more even.

Color rendering

Some packages list a color rendering index (CRI), which describes how naturally colors look under the light. If you care how food, makeup or paint colors look, compare CRI between bulbs.

Fit: shape, base, dimmers and fixtures

Shape and base

Bulbs come in different shapes (like the standard A shape, globes, candelabra, floodlights and tubes) and bases (like the standard medium screw base and smaller candelabra bases). Take the old bulb to the store or photograph it with the fixture.

Dimmers

Not every LED is dimmable. If the light is on a dimmer switch, buy bulbs marked dimmable. Some older dimmers flicker or buzz with LEDs. If that happens, try a different bulb first; if you need a new dimmer switch, that's wiring work, so hire a licensed electrician.

Enclosed fixtures

LEDs are sensitive to heat. In fully enclosed fixtures, like some ceiling domes and outdoor lanterns, use bulbs rated for enclosed fixtures. Otherwise the bulb may wear out early.

Outdoors and damp spots

For porch lights and bathrooms, look for bulbs rated for damp or wet locations as the package describes.

Which bulbs to swap first

  1. Lights that stay on the longest, like kitchen, living room and porch lights.
  2. Lights that are hard to reach, since a long-lasting bulb means fewer ladder trips.
  3. Everything else, as old bulbs burn out.

ENERGY STAR certified bulbs have met the program's requirements for efficiency and performance. You can learn more in our guide to ENERGY STAR appliances.

Disposing of old bulbs

  • Incandescent and halogen bulbs: often allowed in household trash; wrap them to protect workers from broken glass.
  • CFLs and fluorescent tubes: contain a small amount of mercury, so take them to a bulb recycling drop-off or household hazardous waste program instead of the trash. If one breaks, air out the room and follow your state's cleanup guidance.
  • LED bulbs: rules vary. Some areas accept them in trash; others encourage electronics recycling. Check your local program.

While you're gathering bulbs for drop-off, round up dead batteries too. Many household hazardous waste sites take both, and lithium-ion batteries in particular should never go in the trash. Our guide to battery disposal explains how to prepare them.

Lighting habits that still matter

LEDs use less electricity, but switching them off when you leave a room still helps, and it's an easy habit to keep. A few other ideas:

  • Use daylight first. Open blinds during the day and arrange desks and reading chairs near windows.
  • Light the task, not the room. A desk or reading lamp often does the job of a whole ceiling fixture.
  • Add timers or motion sensors outdoors. Plug-in timers and motion-sensing fixtures help porch and yard lights run only when needed. Hardwired sensors and new fixtures are jobs for a licensed electrician.
  • Clean fixtures and shades. Dusty glass and shades dim the light, which can tempt you to turn on more lamps.

Example: a living room swap

Example: Casey's living room had five old bulbs: two lamp bulbs, a ceiling fixture with three candelabra bulbs on a dimmer. They bought one warm white LED to test, liked it, then bought two for the lamps and three dimmable candelabra LEDs for the ceiling. One of the dimmable bulbs buzzed, so they swapped brands and the buzz stopped. The old incandescents went in the trash, wrapped in paper, per their city's rules.

Next easy switches

Lighting pairs well with other small, low-cost changes. Many of the same lamps and fixtures sit near electronics that draw power while "off," so check our guide to phantom power next. If you've already set up a smart thermostat, our guide to smart thermostats covers how connected devices fit into your routine. And if you want to look at bigger projects, insulation basics explains how to tell whether your home is losing heat through the attic and walls, which matters far more for comfort than bulbs do.

Something to do this weekend

Walk through your home and list the five lights you use most. Note each bulb's shape, base, whether it's on a dimmer, and whether the fixture is enclosed. Buy one test LED for the room you care most about, try it at night, and swap the rest once you're happy with the color.

Partner offer · paid placement

Want a step-by-step plan or guide?

Some people like the structure of a paid guide or set of plans. This button opens a third-party program from one of our advertising partners. Its claims are its own, not ours, so weigh them against our checklist for judging paid plans.

See the partner program →

We may be paid when you click. The program shown can change. Read its terms before you buy anything. How this works

Frequently asked questions

How many lumens do I need to replace an old bulb?

Check the old bulb's equivalent wattage, then look for an LED package that lists the same "equivalent" wattage and compare lumens. More lumens means brighter light. Most packages show both numbers.

Should I replace working bulbs with LEDs right away?

You don't have to. A practical approach is to swap the bulbs you use most first and replace others as they burn out. That way you use up what you have and focus on the lights that run the longest.

Can LED bulbs go in the trash?

Rules vary by area. Many places accept LEDs in regular trash, while others encourage electronics or bulb recycling. Old fluorescent and CFL bulbs contain mercury and should go to a bulb drop-off or household hazardous waste program.

See a partner guidePartner offer
Partner offer · paid placement

Want a step-by-step guide?

If you'd like more structure than articles can give, you can look at a third-party guide or set of plans from one of our partners. Its claims are its own. No pressure: our free guides aren't going anywhere.

See the partner program →

We may be paid when you click. How this works